Wednesday June 28th 2017


Bridge Z-Wave and X10 Protocols

One of the most valuable characteristics of building your own home automation system is the ability to personalize it by picking and choosing the devices that meet your needs. However, there are times when you require a product to perform a certain function and that product may not exist for the protocol of your choice.

The history of the X10 protocol dates back to the mid 1970s and X10 devices are still in production today. Throughout the lifetime of X10, engineers and hobbyists have created a large variety of device types from wall modules to light switches, motion sensors, water leak detectors, drive way sensors, and much more. Eventually we will probably see similar devices available that utilize the Z-Wave protocol, but until then we can use existing X10 devices to meet our needs. How can we allow the different protocols to interact with each other? We do this by bridging the communication gap between the two protocols using a home automation controller.

The X10 protocol is known as a power line carrier (PLC) protocol and how it works is straightforward. In the United States, home-based power alternates current direction 60 times a second. Each time it changes direction the voltage at the point of change is zero. X10 sends data over the home’s power lines as close to this point as possible.

The Z-Wave protocol is known as a wireless mesh network protocol and it does not rely on the home’s power lines to transmit data. Everything is transmitted using a radio frequency (RF) signal in the 908MHz signal band.

There is an obvious communications barrier between Z-Wave and X10. They not only speak different languages but they also use two very different methods of transportation. So how do we cross this barrier? By building a bridge using software or hardware. Basically we need something that speaks both protocol languages and provides a logic engine.

The inexpensive solution to this problem is to use a software product such as HomeZix orHomeSeer. You would then use a X10 PC controller such as the W800RF wireless X10 receiver or SmartHome PowerLinc PLC. Both of these X10 controllers communicate with the software using the computer’s serial port. You would also need a Z-Wave PC controller, which comes in many varieties including USB, serial, and Ethernet. HomeZix and HomeSeer both support speaking the X10 and Z-Wave language and they both have built-in logic engines.

Let’s look at a practical example to try and understand the needed components. Say we have installed an X10 driveway sensor and we want that to turn on our Z-Wave light switch to illuminate our driveway when we come home after dark. The driveway sensor would send an X10 message to the X10 PC controller, which would then relay the message to your software. This is where the logic engine comes in to play. The software allows you to react to events in specific ways based on the logic you tell it to perform. For example, you would write a logic statement such as “WHEN driveway is On AND after-sunset is True THEN turn lights On.” The logic engine allows you to accept input from one type of device and react by outputting a message to another type of device. Thus the communication gap has been bridged.

A more expensive, but just as effective, solution to bridging the communications gap is to use hardware controllers. Hardware controllers such as the Elk M1 Gold also contain logic engines that “you,” the installer, must program. The advantage of using a hardware controller is they are typically more reliable and consume less power than leaving a PC on. There are hardware solutions in development that will likely be less expensive than those I’ve already mentioned. One of these is the Wayne-Dalton X-10 Bridge Controller, which, according to the company, is coming soon.

This introduction was created to lay the foundation for subsequent tutorials. In my next article I will walk you through the details of creating a bridge between X10 and Z-Wave using the Elk M1G and related components. I’ve created a bridge in my own home automation system utilizing a W800RF X10 receiver and an EagleEye X10 motion sensor. I placed the motion sensor underneath the dashboard of my car as an extra layer of security. When the motion sensor is turned on the Elk M1 security system makes an announcement and turns on the Z-Wave enabled lighting in my home. I’ll describe this setup in more detail in my next article. Stay tuned.

Twitter Feed